Isciviti alla newsletter
Sezioni
- Shipping (5598)
- Economia (5016)
- Logistica e Trasporti (4434)
- Infrastrutture (3494)
- Nautica (1485)
- Eventi e turismo (952)
- Cultura (201)
- Diritto - Fisco (100)
- Editoriale (14)
Archivio blog
- ► 2023 (2311)
- ► 2022 (1425)
- ► 2021 (1236)
- ► 2020 (1389)
- ► 2019 (1517)
- ► 2018 (1670)
- ► 2017 (1497)
- ► 2016 (2092)
-
▼
2015
(3095)
-
▼
dicembre
(209)
-
▼
dic 17
(9)
- Concessione di 60 anni per il Terminal Container d...
- Da ABB quadri UniSec per i gelati Nestlè
- Ministers agree on fishing catch limits for 2016
- In Italia solo i "piccoli giganti"?
- Fercam: un programma di investimenti di 50 milioni...
- Interporto Sud Europa hub ferroviario della Polonia
- Treatment standards needed for oily galley water
- USCG’s firm stance on ballast water puts Optimarin...
- WSS primed for Asian growth through new Busan hub
-
▼
dic 17
(9)
-
▼
dicembre
(209)
- ► 2014 (3037)
Treatment standards needed for oily galley water
17 Dicembre 2015 - Marine regulators have been urged to introduce performance standards for the separation of fats from galley water before the oily mix enters the onboard treatment process andcauses system failure. Currently there are no IMO standards for the separation of fats, oils and grease from galley water, despite the treated water having to comply with the MEPC 227(64) regulation, which does not allow the discharge of any oils.
Mark Beavis, the Managing Director of water treatment specialist ACO Marine, said: “Galley water should be free of waste sludge, fats, oils and greases before it enters the treatment process otherwise biological overloading and system blockages can occur, causing system failure and possible pollution. “Although there are standards in place for the discharge of treated sewage and bilge water, the industry should develop treatment standards for galley water which would, in the long term, prevent oily galley water being discharged directly overboard or bypassing the treatment system altogether.”
Until performance standards are in place, Beavis said grease separator manufacturers and operators need to take the environmental initiative themselves. “Manufacturers should as a minimum look to match, or exceed, the land-based regulations for grease separator performance covered in the DIN V4040-2/99 and rated at EN1825, or better the EN1825+, which define the limits for lipoid content of any discharge from the separator. Earlier pre-conceived notions that simple grease traps were sufficient have been proven incorrect; they do not take into account neutrally buoyant substances or more dense solids which can spill over into the discharge side of the unit.”
- Blog Comments
- Facebook Comments
Translate
I più cliccati degli ultimi 30 giorni
-
20 aprile 2024 - DEME si è aggiudicata due contratti dal fornitore di soluzioni via cavo Prysmian per i lavori di ingegneria e installazione...
-
20 aprile 2024 - “Il ministro dei Trasporti inviti l’Autorità di Regolazione dei Trasporti a chiarire che nessun contributo è dovuto da par...
-
20 aprile 2024 - L’impianto solare Muelle Príncipe Felipe è ora operativo al 100%. L’infrastruttura è stata collegata alla rete elettrica in...
-
11 aprile 2024 – “Un concreto passo avanti nell’ottica di una sempre maggiore competitività della bandiera italiana nei confronti delle a...
-
20 aprile 2024 - Torghatten Nord ha scelto il cantiere norvegese Myklebust per la costruzione di due traghetti a idrogeno, che trasporterann...
-
19 aprile 2024 — Automar S.p.A. ha annunciato l'organizzazione dell'Open Day dedicato alla professione di autista di bisarca. L’even...